View Single Post
Old 12-18-2013, 11:36 PM
Brucker Brucker is offline
Trail Ready
Join Date: Jul 2013
Location: Longmont, CO
Posts: 436

Picking up from where we left off, we add the last couple of inner vertical supports to each side

With all of the inner pieces tack welded into position, we are able to make the rest of the plates to finish out the front faces.

The next couple of plates on both sides needed slight bends in them in order to make them fit properly

Last edited by Brucker; 03-14-2016 at 11:40 PM.
Reply With Quote