View Single Post
  #53  
Old 12-19-2013, 11:22 PM
Brucker Brucker is offline
Trail Ready
 
Join Date: Jul 2013
Location: Longmont, CO
Posts: 301
Default

With the tubing now having the correct ID, we pull it out of the lathe and part off the two pieces we need using a horizontal band saw so the lathe could get back to work on making the parts we had interrupted.





The left over section of tubing shows just how much material we needed to remove:



Then insert the tubing into the plates that were just made




And then welded them together



The hangers will be able to except the more common sizes of D rings in this industry, 5/8", 3/4", and 7/8" shackles



Now we are able to tack weld them into place




Last edited by Brucker; 03-14-2016 at 10:43 PM.
Reply With Quote