View Single Post
Old 12-30-2013, 12:30 AM
Brucker Brucker is offline
Trail Ready
Join Date: Jul 2013
Location: Longmont, CO
Posts: 436

Continuing on with the backbone, we cut and fit into place the next couple sections

Then a couple more until the backbone is finished out.

Then I fully welded the inside of the bumper together. This will allow us to be able to safely sand out/smooth out all the visible welds without losing any strength. Once the bumper had fully cooled, we pull it off the fab table and install it once again onto the 4Runner. This should be our last test fit if it didn't wrap during welding and if we got all our frame and body clearances right. Here it is installed

And one showing that the backside clears:

Last edited by Brucker; 03-14-2016 at 11:46 PM.
Reply With Quote