Clean bodied 1985 Toyota 4Runner
View Single Post
01-06-2014, 12:00 AM
Join Date: Jul 2013
Location: Longmont, CO
Everything looked good on the test fitting so we once again removed the bumper and clamped it to the fab table. After prepping the backbone we begin welding it solid.
Once the backbone was fully welded together and had cooled, we drilled a hole in each side of the winch tray to accommodate the wiring for the lighting once the bottom is plated.
Now we could finish plating the bumper. We repositioned the bumper on the fab table and clamped it into place. Then took measurements for and cut and tack welded the first set of bottom plates.
We then continued this process:
The next couple sets of plates needed bends for the correct fitment
Last edited by Brucker; 03-14-2016 at
View Public Profile
Send a private message to Brucker
Find all posts by Brucker