View Single Post
Old 01-06-2014, 01:12 AM
Brucker Brucker is offline
Trail Ready
Join Date: Jul 2013
Location: Longmont, CO
Posts: 425

With the bumper still clamped to the fab table we fully welded the bottom plates in. Once cool we removed the clamps to reposition it for final welding.

We clamped two pieces of thick tubing to the front plate (one on the front and one on the rear, pinching the front plate between them) to keep it from warping when we weld the round rod

Then continued to reposition and clamp until the bumper was fully welded inside and out

And started the sanding process:

Last edited by Brucker; 03-14-2016 at 11:47 PM.
Reply With Quote