View Single Post
Old 01-26-2014, 11:44 PM
Brucker Brucker is offline
Trail Ready
Join Date: Jul 2013
Location: Longmont, CO
Posts: 436

Once the bars have cooled enough, we unbolt and remove them for the vehicle and finish welding them solid. He is a photo of the two bars once fully welded, cleaned up, and ready for install. You will notice each bar is bent in a different shape to accommodate each side's different mounting brackets.

Then we install the bars into position

With the door and bars installed, you can easily see how tight to the door the finished bars are:

Next item was the main hoop or B pillar hoop. All bent up, notched and ready for install:

You will notice how again, each leg is different to fit as tight as possible and allow full use of the front and rear seats:

Tack welded into position

Folded down rear seat still works

Last edited by Brucker; 03-14-2016 at 11:55 PM.
Reply With Quote