View Single Post
Old 01-26-2014, 11:44 PM
Brucker Brucker is offline
Trail Ready
Join Date: Jul 2013
Location: Longmont, CO
Posts: 425

We prep a couple areas on the factory roll bar where we are going to tie in the new tube work.

Then bend up and notch a couple top bars to go between the B pillar and the factory roll bar and tack them into place:

Then cut and notched a couple gusset bars for the rear and tack welded them into position:

Last edited by Brucker; 03-14-2016 at 11:56 PM.
Reply With Quote