Clean bodied 1985 Toyota 4Runner
View Single Post
01-30-2014, 11:10 PM
Join Date: Jul 2013
Location: Longmont, CO
Finally found a little more time to go through some more of the photos so I can update this thread.
Bent up and notched the driver's side A pillar/door bar.
Tack welded into position
Before we could move on to the passenger side, we needed to remove the factory grab handle. And since we were dismantling something already we also removed factory rear view mirror. This will be replaced by a more modern unit which features a built in compass and temperature gauge. We will be filling in the holes that will be left of with small sheet metal plates.
Last edited by Brucker; 03-15-2016 at
View Public Profile
Send a private message to Brucker
Find all posts by Brucker