View Single Post
  #8  
Old 02-26-2014, 03:39 PM
kurtnkegger's Avatar
kurtnkegger kurtnkegger is offline
Rising Sun Member
 
Join Date: Jan 2011
Location: Denver Burbs
Posts: 272
Default

Matt, when my hot air intake was stuck to always take in the hot air by the exhaust manifold, I would stall at water crossings, or anything that would cause steam to rise and mix with the air that was being sucked in to my carb. This sounds like it would fall in line with the symptoms you are describing. I would check your air intake gate in your air filter housing to verify it's moving as it should. I used a wire tie to keep my gate open to always accept cold air away from the manifold, until I found a working replacement, and never had stalling issues after that.
Reply With Quote