View Single Post
  #2  
Old 10-31-2005, 09:05 PM
nakman's Avatar
nakman nakman is online now
Rising Sun Commander
 
Join Date: Aug 2005
Location: north side
Posts: 9,788
Default

Install...

Pop off the door panel, then take out two of the screws that are holding the "door panel trough thing" on. You want to be able to pry it out from the panel itself, just enough to poke a hole in the fabric and run the wires through it, to the inside of the panel. The wire feeds through the crack between the "panel trough" and the panel itself, I used a stubby screwdriver as a third hand to keep them separated while feeding the wire.

Then secure the LED to the edge of the trough using a couple screws, and tap into the power of the existing door light. The blue wire w/ the yellow stripe is the positive. Button everything up, then pop the panel back on.
Attached Images
  
__________________
99 uzj100, 05 525EXC

www.gamiviti.com


Last edited by nakman; 10-31-2005 at 09:09 PM.
Reply With Quote