View Single Post
Old 06-02-2008, 07:58 PM
Mendocino's Avatar
Mendocino Mendocino is offline
Rising Sun Member
Join Date: Sep 2005
Location: North Side
Posts: 1,736
Default Follow up

I took a much closer look and discovered that the rotor is slightly loose, not the hub on the spindle. I will attempt to tighten the Torx fasteners that hold it on, but it should not make much difference because the wheel will push the rotor against the hub flange when the lug nuts are tightened.
03 UZJ100 (2.5" OME/Slee suspension), Slee Step-Sliders, LEDs, cross drilled and slotted rotors by PowerStop, and some other goodies.
75 FJ40; 355 HP/405 FP torque/ fuel injected ZZ4; Snorkel, 700R4 tranny, Orion, ARBs F&R, armored, winch, ...; and now weighing in at 4370 lbs.
Reply With Quote