View Single Post
  #16  
Old 06-24-2008, 01:35 PM
wesintl's Avatar
wesintl wesintl is offline
Hard Core 4+
 
Join Date: Aug 2005
Location: in da house
Posts: 7,607
Send a message via AIM to wesintl
Default

Quote:
Originally Posted by RicardoJM View Post
This might make an interesting poll question, for others that have done the disc brake conversion - did you use a knuckle centering tool or re-use the shims as they came off?
If you are just rebuilding the knuckle on the existing housing reusing the shims or replacing them with new ones with the same thinkness's is fine (at least IMHO) if you are putting the 60 knuckles on a different housing (like your 40) you need to measure it or build your own tool so the knuckle is centered properly. Last thing you want to do is rebuild the whole thing over again if it's causing seal failure because it's not shimmed properly. The marlin seals are better but if it's off enough they can fail. I wouldn't risk it esp when subzali has a tool.
__________________
See you on the trail
WREK
Couple o' FJ40's, BJ70, UZJ100, TDI 66FJ40,82FJ60,97FZJ80
TLCA#4180
Reply With Quote