View Single Post
Old 04-07-2013, 10:27 AM
kvanoort's Avatar
kvanoort kvanoort is offline
Join Date: Oct 2006
Location: Lafayette, CO
Posts: 201
Default Factory Roll Bar Location?

I'm installing a Metal Tech Full Profile Cage into my '72 40 and need location measurements of the bolt holes for a factory roll bar on the wheel wells. My vehicle didn't come with a factory roll bar and the rear mounting plates for the cage use the factory bolt holes to correctly position the base plate. If someone could measure the distance of the roll bar bolt holes from the front and side edges on the wheel well and post them up I would greatly appreciate it. Thanks.
Kent Van Oort
Lafayette, CO
1972 FJ40 Current Project, 1978 FJ40 Sold Project, 1975 FJ40 High School Cruiser
TLCA #17904
Reply With Quote