View Single Post
Old 05-16-2010, 08:08 PM
nuclearlemon's Avatar
nuclearlemon nuclearlemon is offline
Hard Core 4+
Join Date: Aug 2005
Location: denver
Posts: 6,553

Originally Posted by Uncle Ben View Post
Any exhaust shop will have both the flanges and possibly some mandrel bent pre-bends.
son of a.... i was searching for "flanges"...

got it "done". a couple small exhaust leaks where i welded, mainly cause i can't get to the top of the pipes to get them. it will most likely make a bit of a rattle, cause it's way too close to the frame to not hit it. hopefully that will motivate me to fix it sooner i was two clamps short, so i'll get those tomorrow.

also got 3 of the frame braces for the new slider welded on. got to make the fourth. the p.o. didn't put anything on to distribute the impact and it's kind of hard to see in photos, but your frame will bend.
Attached Images
ige tlca #1431
62 fj40
65 fj45
71 fj55
78 fj55
95 fzj80
96 fzj80
Reply With Quote