View Single Post
  #14  
Old 10-03-2010, 05:15 PM
gr8fulabe's Avatar
gr8fulabe gr8fulabe is offline
Rising Sun Member
 
Join Date: Sep 2005
Location: Boulder Canyon
Posts: 704
Default

So, I put my finger over the first plug hole to feel compression & had my wife bump the starter to get it close to TDC. It was actually just a bit past the bb, but when I pulled the cap the rotor was pointed towards the number one cylinder spot. So I feel like it should is in the correct area & should start, but will only sort of run while the ignition still turned to keep the starter moving. But it fails immediately after that.
Any ideas if there could be something else wrong here?
Thanks,
abe
Reply With Quote