Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Toyota 4x4 > General Tech Forum

Reply
 
Thread Tools
  #1  
Old 07-10-2012, 05:35 AM
tipito147's Avatar
tipito147 tipito147 is offline
Rock Stacker
 
Join Date: Jan 2009
Location: Thornton CO
Posts: 17
Default Need help with harness for Rear Lockers

I have a 1994 Landcruiser that used to not have lockers until I bought another 1994 with a bad motor. I put the lockers from that truck onto mine.
The front differential, the dial switch, the ECU, the harness in the front and the bulbs on the dash are all instaled and functioning perfectly.
Now, when it comes to the back differential, its a different story. I swaped the differentials and installed the harness that goes from the differential to the panel with the ABS harness. And Im stuck.
How do I continue?
Where does the harness end?
Pictures would help a lot! Especially ones showing where the wires go to.
Can I run new wires or do I have to open the harness of the other truck and take out the 5 wires?
Thanks for your help
Reply With Quote
  #2  
Old 07-11-2012, 08:54 AM
TIMZTOY's Avatar
TIMZTOY TIMZTOY is offline
Hard Core 4+
 
Join Date: Apr 2009
Location: Denver
Posts: 1,887
Default

It might not help.
But I installed elockers on my 84 pickup and just ran them all they way with my own harness. You should be able to do the same just extend the wiring to a point you know. Even if it is the dash
__________________
TLCA # 20314
84 Hilux, 22re Conversion, 63" chevy rears, Rears up front, Bobbed bed, duel e-lockers, 5.29's, 35" Ground Hogs low compression
Step by Step Bed Bob
Reply With Quote
  #3  
Old 07-11-2012, 09:10 AM
Inukshuk's Avatar
Inukshuk Inukshuk is offline
Rising Sun Member
 
Join Date: Aug 2005
Location: Denver, CO
Posts: 2,759
Default

Have a 93 in Sloan's Lake you can look at.
__________________
Daniel Markofsky - Daniel@Markofsky.com KDGWR
Denver, Colorado, TLCA # 9972, http://risingsun4x4club.org/
1993 FZJ80 "enhanced", re-built Engine, and prototype GOBI Stealth roof rack
Reply With Quote
  #4  
Old 07-11-2012, 07:29 PM
powderpig's Avatar
powderpig powderpig is offline
Hard Core 4+
 
Join Date: Aug 2005
Posts: 1,345
Default

When you removed the axle from the donor truck did you not see where the wiring harness went? Is you current truck a model with a drum brake system in the rear. If not, then you have a great aide to help you figure this out. Look at the donor truck and see where the wiring harness goes to. If you do not have the donor truck any more that may be a issue. You may also need to follow the pig tail that was left behind on the donor to see where it is plugged into and then you can go do the replace part of this.
Unless you got rid of the donor truck, you should have all that you need.
Reply With Quote
  #5  
Old 07-12-2012, 09:45 PM
tipito147's Avatar
tipito147 tipito147 is offline
Rock Stacker
 
Join Date: Jan 2009
Location: Thornton CO
Posts: 17
Default

Quote:
Originally Posted by Inukshuk View Post
Have a 93 in Sloan's Lake you can look at.
Thanks for your offer!!! i already found it, and its ready to go!!!!
Reply With Quote
  #6  
Old 07-12-2012, 09:49 PM
tipito147's Avatar
tipito147 tipito147 is offline
Rock Stacker
 
Join Date: Jan 2009
Location: Thornton CO
Posts: 17
Default

Here is the link for the answers I found. Maybe this will help someone in the future.

http://forum.ih8mud.com/80-series-te...-needed-3.html
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 09:04 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.