Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Toyota 4x4 > General Tech Forum

Reply
 
Thread Tools
  #11  
Old 02-01-2013, 05:40 PM
Air Randy's Avatar
Air Randy Air Randy is offline
Rising Sun Member
 
Join Date: Aug 2008
Location: Franktown, CO
Posts: 2,804
Default

If you are going to add a lift, then definitely wait to adjust any drive shafts lengths until after that is done. Just make sure you have the right yokes and flanges available for both DS's. Once the lift is in, the drive shaft place will tell you where to measure from in order for them to make shafts the right length.

How big is your lift? Back when I did a 4" lift on my 40 I had to lengthen the rear shaft. Then I discovered it put so much angle on the pinion I had to rotate the diff up and re-weld the spring pads. That caused a vibration which required adding a CV joint to the top of the driveshaft.
__________________
Randy Rosetta KDKWX TLCA #19351 69 FJ40 "Meanie" & 1970 Boss 302 Mustang
Reply With Quote
  #12  
Old 02-01-2013, 05:40 PM
Hulk's Avatar
Hulk Hulk is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: South Side!
Posts: 11,492
Send a message via AIM to Hulk
Default

Southside driveshaft experts:

Bill's Englewood Driveshaft
"You Can't Beat My Shaft!"
www.billsenglewooddriveshaft.com
3364 1/2 S. Broadway
Englewood, CO 80113
(303) 781-0554
__________________
Matt Farr, Centennial, Colorado | Webmaster: TLCA.org
1996 FZJ80 TLCA #4189 WRDY
www.rustybrain.com/cruisers my Rising Sun bio Facebook Twitter Need satellite Internet? Check out: Exede Internet

If you think you can or think you can't, you're right.
Reply With Quote
  #13  
Old 02-01-2013, 11:04 PM
bigcity25's Avatar
bigcity25 bigcity25 is offline
Locked
 
Join Date: Nov 2010
Location: Denver
Posts: 270
Default

Only doing a 2.5 mainly to allow for the 33's and replace the old sagging suspension.

At Jeff: we just used the 3 spd ds yoke on the front just to connect the ds temporally. Then I ordered the correct flange from cruiser outfitters and installed it. Now my driveline minus the transfercase is all 4 speed.
__________________
Jeff Billingsley
Denver Colo
7/70 Fj40
desmogged 2f, 4 speed
TLCA #21898
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 10:12 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.