Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Toyota 4x4 > General Tech Forum

Reply
 
Thread Tools
  #11  
Old 02-26-2008, 07:38 AM
Red_Chili's Avatar
Red_Chili Red_Chili is offline
Hard Core 4+
 
Join Date: Aug 2005
Location: Littleton CO
Posts: 8,409
Default

I used 4Crawler sliders with the heavier 3/16" square tubing. They will not move, nor dent, nor bend. FWIW, Roger uses 1/8" for the outrigger legs as they are plenty strong and it saves weight. But the slider tubes are 3/16", both the outside tubes and the tube under the body pinch weld. The square tubing actually is a bit thicker in the corners where they get the most abuse, around .250.

I have built two sets of sliders with simple square tubing now, using 1/8" for outrigger legs and 3/16" for the slider tubes. Bombproof. Flapsander and Hammerite restores them to like-new.

You will find plenty of uses for your 1/8" tube. Or, I bet Altitude will swap you FWIW. Just 'splain it to 'em.
__________________
-Bill Morgan
Heb Dduw, heb ddim; Duw a digon
Abnormally aspirated
KDěRCH
Bio Page
I'm that gun-totin', farm-raised, evangelical, pro-environment, OHV ridin'/drivin', Southern civil rights pro-labor Liberal yo' momma told you couldn't possibly exist.
Reply With Quote
  #12  
Old 02-26-2008, 08:24 AM
60wag's Avatar
60wag 60wag is offline
Rising Sun Member
 
Join Date: Aug 2005
Posts: 1,796
Default

To further complicate the issue... different materials will have different yield strengths. the cheaper welded tube will bend before a DOM seamless tube with the same wall thickness. The yield strength will also affect your ability to fab curves in it. With a stout hydraulic bender, the DOM is not a problem (within reason) but with a manual tubing bender, a lower strength, thinner wall may be the difference between a nicely formed curve and a kinked mistake.
__________________
Bruce
'96FZJ80
'03 KTM 450EXC
"If you know what you're doing, then you aren't learning anything." - A. Lincoln
Reply With Quote
  #13  
Old 02-26-2008, 09:01 AM
J Kimmel J Kimmel is offline
Hard Core 4+
 
Join Date: Oct 2005
Location: Lakewood
Posts: 920
Default

all the .120 wall dom in my cage bent fine with a manual pro tools so did the misc HREW in there too. Maybe in a pipe bender or with much heavier wall but there are no kinks in my cage, only behind the wheel.
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 01:08 AM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.