Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Toyota 4x4 > General Tech Forum

Reply
 
Thread Tools
  #21  
Old 06-30-2008, 11:56 AM
Hulk's Avatar
Hulk Hulk is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: South Side!
Posts: 11,463
Send a message via AIM to Hulk
Default

Englewood Driveshaft off South Broadway could do it for you.

It's not that hard to replace a U-Joint -- I did all four in my garage on a Saturday afternoon.
__________________
Matt Farr, Centennial, Colorado | Webmaster: TLCA.org
1996 FZJ80 TLCA #4189 WRDY
www.rustybrain.com/cruisers my Rising Sun bio Facebook Twitter Need satellite Internet? Check out: Exede Internet

If you think you can or think you can't, you're right.
Reply With Quote
  #22  
Old 06-30-2008, 11:58 AM
Romer's Avatar
Romer Romer is online now
Rising Sun Member
 
Join Date: Aug 2005
Location: Englewood, Colorado
Posts: 7,123
Default

Just go to englewood drive shaft on south Broadway and the will rebuild and balance your drive shaft for about $200 including the U Joints. make sure they use Toyota and have them order from Burt asking for the RS club discount or you could go get them at Stevenson and drop them off. Balancing is important as well.
__________________
Ken Romer - K0ROM
04 UZJ100
77 FJ40
11 RX350
02 Kimberley Kamper

Reply With Quote
  #23  
Old 07-02-2008, 11:31 AM
timmbuck2's Avatar
timmbuck2 timmbuck2 is offline
Rising Sun Member
 
Join Date: Oct 2005
Location: Denver
Posts: 3,042
Default

Should I replace both the spider and the flange yoke? the flange yoke is what is broken...at Stevinson it is about $120 with RS discount to get just 1 spider and flange yoke...
__________________
* 00 LC
* stinky old Ford Diesel tow rig (FOR SALE)
* 01 RX300 with a seized motor
KDTIM
TLCA# 15572
TLCA Executive VP 2008-2011
CM Committee Member CM10, CM11
Reply With Quote
  #24  
Old 07-02-2008, 04:09 PM
Hulk's Avatar
Hulk Hulk is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: South Side!
Posts: 11,463
Send a message via AIM to Hulk
Default

Does the spider (Toyota-ese for u-joint) turn freely on all 4 caps? Are the needle bearings all still intact? If it is OK, you could probably re-use it. It is a wear item, so it will eventually need to be replaced, but they do last a long time.
__________________
Matt Farr, Centennial, Colorado | Webmaster: TLCA.org
1996 FZJ80 TLCA #4189 WRDY
www.rustybrain.com/cruisers my Rising Sun bio Facebook Twitter Need satellite Internet? Check out: Exede Internet

If you think you can or think you can't, you're right.
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 06:39 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.