Rising Sun Member Forums  

Go Back   Rising Sun Member Forums > Toyota 4x4 > General Tech Forum

Reply
 
Thread Tools
  #1  
Old 09-08-2008, 03:47 PM
Air Randy's Avatar
Air Randy Air Randy is offline
Cruise Moab Committee
 
Join Date: Aug 2008
Location: Franktown, CO
Posts: 2,804
Default Cut & Turn Question

Can anyone recommend a good place to go in Denver or Colorado Springs that can do a cut & turn on my front SOA axle? Any idea how much this usually costs?

Same question in regards to where I can go to have a long travel front & rear drive shaft made to fit my 1974 FJ40?
Reply With Quote
  #2  
Old 09-08-2008, 03:59 PM
Hulk's Avatar
Hulk Hulk is offline
Cruise Moab Committee
 
Join Date: Aug 2005
Location: South Side!
Posts: 11,420
Send a message via AIM to Hulk
Default

Question 1.
Irbis Offroad
Rocky Mountain Cruisers
Colorado Toyota Specialists

Question 2.
Englewood Driveshaft
__________________
Matt Farr, Centennial, Colorado | Webmaster: TLCA.org
1996 FZJ80 TLCA #4189 WRDY
www.rustybrain.com/cruisers my Rising Sun bio Facebook Twitter Need satellite Internet? Check out: Exede Internet

If you think you can or think you can't, you're right.
Reply With Quote
  #3  
Old 09-08-2008, 04:44 PM
subzali's Avatar
subzali subzali is offline
Rising Sun member
 
Join Date: Aug 2005
Location: Denver CO
Posts: 7,573
Default

Question 1.
you can also ship to Proffitt's Cruisers out in Montrose, or send it to Kurt at Cruiser Outfitters. If you care to ship it out of the area.
__________________
Matt Miller
TLCA# 13684
Rising Sun Bio
1977 FJ40 2F "Brahma" + Lockright, tach, Warn 8274, FJ60 Power Steering, soon to lose the Sanden OBA to go back to factory emissions
1996 FZJ80 1FZ-FE factory lockers + Safari Turbo , CDL switch, cup holder, AATLAS1X leather, heated seats and JDM switches
2000 Tundra Limited TRD 2UZ-FE SOLD
Reply With Quote
Reply

Thread Tools

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


All times are GMT -6. The time now is 02:18 PM.


Powered by vBulletin® Version 3.7.1
Copyright ©2000 - 2014, Jelsoft Enterprises Ltd.